Acrylic Bathtub Refinishing
Chips scratches and wear always make a bath look old and outdated. However, if you opt to go for a new tub, you may find yourself spending a lot of time and money on the process. Unless you have to, it is advisable to avoid this process, especially when your bathtub condition can get repaired. If you have an acrylic bathtub that is stained or worn out then you may need to contact experts from San Diego bathtub reglazing & resurfacing contractors.
These experts will help you fix the damaged areas of your tub, including filling the cracks painting amongst many other things. This process is advantageous to you because it cost you little money and time to fix the problem. However, if you consider the problem to get fixed minor, then you can even do it yourself provided you have the right apparatus.
The apparatus used in the bathtub refinishing process is easy to access, and with the steps below, you should be able to carry out an acrylic bathtub refinishing process successfully and within a very shorter period.
You first need to start by removing all the caulking using a screwdriver. After you are sure that all the caulking has gotten obliterated you can now proceed to wipe the area using alcohol known as isopropyl. If there are any remnants still, then you can now remove them with the use of a caulking life. This removal is to ensure the surface is completely free of silicone caulking.
If you get convinced that the caulking is now completely removed, go ahead and clean the surface. During the cleaning process, use washing soda. After you have washed the surface thoroughly, rinse it and dry. The rinsing will eliminate any traces that might have remained on the surface, including the bathing soap.
After carefully cleaning the surface, you can now proceed to remove the rust stains with the use of a sander. Usually, a hand sander gets preferred in this process due to its size which makes it possible for you to maneuver it on the surface of the tub much more comfortably. You can buy this hand sander from any local store. It is readily available and is also relatively cheap.
After sanding the entire area. You can now start to carefully fill the chipped or deeply scratched fields on the surface of the bathtub using an epoxy compound. After filling the deep scratches, give the surface time to dry. The drying time will vary depending on the nature of the materials you use. After ensuring that the filling compound you used is completely dry, you can now move on to sand the surface with the use of a hand sander.
After finishing with the sanding tape, you might now go ahead to tape the area or the walls around the bathtub area. This covering will assist you to avoid spraying the walls may accidentally in cases of an overspray. Try and use a wide roll masking tape when taping the walls. The tape works well and covers more space.
After securing the area around, you can now continue to apply the coat premier to the surface of the bathtub using a paintbrush. After painting allows the surface sometime to dry, then you can ask for the second layer.
After ensuring that the surface is dry, you can now move on to apply three other thin acrylic layers. Ensure to use a high volume low-pressure paint sprayer for the best results. Also, ensure to keep sanding between each coat of paint to give your tub a glossy appearance.
The above tips should act as a guide to you in case you choose to refinish your bathroom by yourself. However, it is essential to note that for this process to be a success, you may have to be extremely careful taking each step at a time. In case you feel you may not be able to carry out this procedure successfully, you may need to contact experts from San Diego bathtub reglazing & resurfacing contractors to come and assist you. They may not be able to do the task, but they will surely give you the right guidance through the process.